Advertisement
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com
4.0 Start-up and Operation
4.1
General:
1
3
Screen Instructions:
1.
RPM Display- Displays current RPM of motor.
2.
RPM slight increment buttons- Use these up and down arrows to adjust the RPM by increments of 1.
Hold to increase RPM at a more rapid rate
3.
RPM Adjustment Slider- Press and hold to move the slider left and right. This slider adjusts RPM
rapidly. The slider location is proportional to the RPM range of the PICO 155S. Leftmost location is 0
RPM, rightmost location is 1500 RPM.
4.
Start/Stop- Press to start and stop the machine
5.
Programmable RPM Preselects- Press one of the three buttons to change the RPM to the displayed
number. Press and hold to customize each button to preferred RPM setting
6.
Dress Wheel- Non-programmable RPM select button used to set the RPM to the recommended
dressing blade speed for the PICO-155S saw.
7.
Pump Control- Manual and automatic pump control buttons. When in auto mode the pump will activate
once the Start/Stop button is pressed. Pump ON/OFF is used to toggle the pump on and off at any time.
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
PICO-155S Precision Saw
The PICO-155S is a low-medium speed precision wafering saw.
5
I
NSTRUCTION
2
4
6
M
ANUAL
Web: http://www.metallographic.com
7
14
Advertisement
