Land Pride SB10 Series Operator's Manual page 38

Section 6: Maintenance & Lubrication
SB1051 & SB1064 Gearbox
SB1574 & SB2584 Gearbox
NOTE: Use a suction or siphon pump to drain
gearboxes of oil when there is not an oil drain plug.
36 SB1051, SB1064, SB1574, & SB2584 with S/N 881641+ Snow Blowers 370-430M
Table of Contents
33293
Do Not
Overfill
Gearbox
NOTE: Do not overfill! Snow Blower should be level
when checking oil. Oil expands when hot, therefore,
always check oil level when cold.
Remove oil level plug shown with arrow. If oil is below
bottom of plug hole, add recommended gear lube
through oil level plug hole until oil flows out of the hole.
Reinstall and tighten oil level plug.
Type of Lubrication: 80-90W EP Gear Lube
Do Not
Overfill
Quantity = Fill until oil begins to flow out of oil level plug
hole in gearbox.
33294
Driveline U-joints
Driveline U-joint with grease every 8 hours of operation
2 - Zerks
Type of grease = Multi-Purpose
Quantity = Coat Generously
33302
Driveline Shaft
Disconnect driveline shaft from the tractor and slide
apart. Clean and coat the inner tube of the driveline shaft
with a light film of grease and then reassemble.
Type of grease = Multi-Purpose
Quantity = Coat Generously
23759
As
Required
10
Hours
10
Hours
10/12/16