Land Pride SB10 Series Operator's Manual page 15

Section 2: Optional Assembly & Set-up
Manual Deflector Assembly
Figure 2-7
Manual Deflector Assembly
Refer to Figure 2-7:
Attach lower single hole in adjustment deflector 
1.
arm (#1) to lower discharge chute lug "A" with
adjustment pin (#2). Secure adjustment pin with
hairpin cotter (#3).
2. Attach one of the multiple upper holes to the upper
deflector lug "B" with adjustment pin (#2). Secure
adjustment pin with hairpin cotter (#3).
37092
Outer Skid Shoe Assembly
Figure 2-8
Skid Shoes, Outer
Refer to Figure 2-8:
1. Attach right-hand skid shoe (#1) to upper hole "A" with
3/8"-16 x 1" GR5 carriage bolt (#2A) and hex flange
lock nut (#3).
2. Attach right-hand skid shoe (#1) to hole "B" or "C"
with 3/8"-16 x 1" GR5 carriage bolt (#2B) and hex
flange lock nut (#3).
3. Tighten lock nuts to the correct torque.
4. Repeat steps 1 and 3 above for the left-hand skid
shoe using the same mounting holes as before.
10/12/16
Table of Contents
37087
Skid Shoes, Inner
Refer to Figure 2-9:
1. Attach skid shoe mounts (#2) to both sides of the
Snow Blower frame with 3/8"-16 x 1" GR5 bolts (#4),
backing plates (#3), and hex flange lock nuts (#5).
Tighten lock nuts to the correct torque.
2. Insert skid shoes (#1) into skid shoe mounts (#2).
3. Install 1" spacer (#9), 1/2" spacer (#8), and four flat
washers (#6) over shaft of each skid shoe.
4. Secure skid shoes (#1) with 1/4" x 1 3/4" wire
retaining pins (#7).
5. Make certain wire retainers are caught over end of
pins to keep skid shoes from falling out.
SB1051, SB1064, SB1574, & SB2584 with S/N 881641+ Snow Blowers 370-430M
Inner Skid Shoe Assembly
Figure 2-9
37093
13