Land Pride SB10 Series Operator's Manual page 22

Section 3: Tractor Hook-up & Unhook
Unhooking Snow Blower
1. See "Long Term Storage" on page 34 before
parking Snow Blower for a long period.
2. Disengage PTO, park on a level solid surface, and
lower Snow Blower to ground level.
3. Place gear selector in park or in neutral with park
brake set, shut engine off, remove switch key, and
wait for PTO to stop before dismounting tractor.
4. Hydraulic Options:
a. With tractor shut off, move hydraulic control
levers back and forth several times to relieve all
hydraulic pressure in hydraulic hoses.
b. Disconnect hydraulic hoses from tractor duplex
outlets.
c. Wrap hydraulic hoses around Snow Blower hitch
frame for storage and to keep dirt away from quick
disconnect couplings.
5. Electrical Options:
Refer to Figure 3-7:
a. Disconnect electric motor (chute rotation) wiring
harness (#7) from control box (#1). Coil harness
up and tie to Snow Blower hitch frame.
b. Disconnect electric actuator (deflector wiring
harness (#8)) from control box (#1). Coil harness
up and tie to Snow Blower hitch frame.
c. Disconnect black negative (-) wire lead (#11) from
power source.
d. Disconnect red positive (+) lead (#10) from power
source.
e. Remove control box (#1) from tractor, wrap wiring
harness (#13) up in a coil and tie coils together to
keep coils from unwrapping.
f. Store wiring harness (#13) and control box (#1) in
a dry location.
Refer to Figure 3-8:
6. Pull back on driveline pull collar (#8) and hold while
pulling driveline yoke from tractor PTO shaft.
47298
20 SB1051, SB1064, SB1574, & SB2584 with S/N 881641+ Snow Blowers 370-430M
Table of Contents
Driveline Installation (Shown with 3-Point Hitch Fully Extended)
7. Remove top center hitch pin keeper and hitch pin. If
provided, place center 3-point link in tractor's holding
clip.
8. Remove linchpins (#5) and hitch pins (#1) from lower
3-point lift arms.
9. Drive tractor forward several feet. Place gear selector
in park or set park brake, shut tractor engine off,
remove switch key, and dismount tractor.
10. Reinstall hitch pins, linchpins, and hair pin cotters in
the Snow Blower hitch for safe keeping.
11. Collapse driveline (#7) by pushing tractor end of
driveline towards the Snow Blower.
12. Support collapsed driveline off the ground to keep
dirt away from yoke pull collar and bearings.
Power
Terminal
White/Black
Deflector Terminal
Red/Black
Rotate Terminal
Black Wire Red Wire
Negative (-) Positive (+)
Figure 3-8
Deflector
White Toggle
Chute Rotate
Red Toggle
Chute Rotate
Wire Harness
10 Amp fuse
Deflector
Wire Harness
Electrical Hook-up
Figure 3-7
Control
Box Mount
33291
37095
10/12/16