Land Pride SB10 Series Operator's Manual page 14

Section 2: Optional Assembly & Set-up
Hydraulic Deflector Assembly
Figure 2-5
Hydraulic Deflector Assembly
Refer to Figure 2-5:
1. Screw O-ring end of 9/16" elbows (#4A & #4B) into
hydraulic ports of cylinder (#3). Do not tighten elbows
at this time.
2. Screw 1/4" x 80" long hydraulic hose (#5) to 
elbow (#4A) until tight.
3. Screw 1/4" x 85" long hydraulic hose (#6) to 
elbow (#4B) until tight.
4. Attach base end of hydraulic cylinder (#3) to lower
chute lug "A" with 1" clevis pin (#1). Secure clevis pin
with cotter pins (#2). Bend one or more legs of cotter
pins (#2) to keep pins from falling out.
5. Attach rod end of hydraulic cylinder (#3) to deflector
lug "B" with 1" clevis pin (#1). Secure clevis pin with
cotter pins (#2). Bend one or more legs of cotter pins
(#2) to keep pins from falling out.
6. Tighten elbows (#4A & #4B) to hydraulic 
cylinder (#3) until tight.
7. Screw quick disconnect couplings (couplings
furnished by customer) to hydraulic hoses (#5 & #6)
until tight.
8. Attach High Pressure Fluid Decal 848-747C (#7) in
the location shown. See "Safety Labels" on page 4
for installation instructions.
9. Coil hydraulic hoses (#5 & #6) around Snow Blower
mainframe for safe keeping.
12 SB1051, SB1064, SB1574, & SB2584 with S/N 881641+ Snow Blowers 370-430M
Table of Contents
37089
Electric Deflector Assembly
Refer to Figure 2-6:
1. Attach actuator rod ends (#1A & #1B) to both ends of
actuator (#7) as shown with 1/2"-13 x 1 3/4" GR5 cap 
screws (#3) and hex flange lock nuts (#4). Tighten
lock nuts to the correct torque.
2. Attach lower rod end (#1A) to lower chute lug "A" with
adjustment pin (#2). Secure adjustment pin with
hairpin cotter (#5).
3. Attach upper rod end (#1B) to deflector lug "B" with
adjustment pin (#2). Secure adjustment pin with
hairpin cotter (#5).
4. Attach wire harness (#6) to electric motor (#7).
5. Coil wire harness (#6) up and store on the Snow
Blower mainframe.
Electric Deflector Assembly
Figure 2-6
37088
10/12/16