Epson Stylus TX235 Service Manual page 57

Epson Stylus SX230 series / SX235W series / SX430W series / SX440W series
Enlarged figure Apply on the
center of inner
wall (x4 points).
Figure 4-13. Lubrication of the Scanner Carriage (2)
Combination gear 14.4,10.8
Scanner Carriage
Cross-section
Pinion Gear
Scanner Motor
Figure 4-15. Lubrication of Scanner Motor, Combination Gear 14.4,10.8 and Combination Gear 13.8,9.66
Maintenance
Scanner Carriage
<Remarks>
Application Point
Combination gear 13.8,9.66
<Lubrication Point>
1. Gear sections (x2) on the
2. Shaft hole of the
Cross-section
3. Shaft hole of the
<Remarks>
1.
2.3. After applying with
Application Point
<Part supply as ASP>
Supplied as the Scanner
Unit
<Lubrication status when
supplied as ASP>
Lubricated
<Lubrication Point>
On inner wall surfaces (x4)
on the groove of the
Scanner Carriage
<Type>
G-45
<Application Amount>
0.01 g x 4 points
Using injector, apply
grease on inner wall
surfaces (x4) on the
groove shown in the
enlarged figure.
Be careful not to let
grease flow over.
<Part supply as ASP>
Supplied as the Scanner Unit
<Lubrication status when
supplied as ASP>
Lubricated
Pinion Gear of the
Scanner Motor
Combination Gear 14.4.10.8
Combination Gear 13.8.9.66
<Type>
G-45
<Application Amount>
1. 0.01 g x 2 points
2.3. 0.01 g
Apply with injector.
injector, spread it over
the entire inner surface
the shaft hole shown in
the figure.
Be careful not to let
grease flow over.
Lubrication Points and Instructions
Panel Stand
Application Point
Figure 4-14. Lubrication of the Panel Stand
Revision B
<Part supply as ASP>
Supplied as the Panel Unit
<Lubrication status when
supplied as ASP>
Lubricated
<Lubrication Point>
Shafts (x4) of the Panel
Stand
<Type>
G-74
<Application Amount>
Appropriate amount
<Remarks>
Using flux dispenser,
apply all over the shafts
shown in the figure.
Stir G-74 before use.
57
Confidential