Restoring The Speaker To Factory Defaults - Denon HEOS HomeCinema HS2 Owner's Manual

Contents

Restoring the speaker to factory defaults

Restoring the HEOS device to its factory defaults will clear all of the settings and restore the original software which was installed
at the factory.
Caution
All settings will be erased and the software will likely be downgraded!
0
To restore your HEOS speaker to the factory defaults, unplug the power cable from the back of the HEOS speaker. Press and
hold the Bluetooth button located on the back of the HEOS speaker, reconnect the power cable, and hold it in until the front LED
begins to flash amber.
* For further information, please visit http://www.HEOSbyDenon.com
HEOS HomeCinema takes long time to turn on
In case the HEOS HomeCinema as in the DEEP standby mode, it may takes around 40 second to turn on.
Setup Use
Solution
Solution
Troubleshooting
67
Status LED Appendix
Refer to Page
Refer to Page
–
–