Table of Contents
Advertisement
Part names and functions
Rear panel (DSW-1312)
q
Line input connector (LINE IN)
Connect this connector to the amplifier's "SUBWOOFER PRE
OUT" connector using the included audio cable.
w
Volume adjustment control (LEVEL)
Use this control to adjust the volume of the subwoofer.
e
Status indicator
The two-colored light indicates the subwoofer's operating status,
as follows:
• Power "ON" ··································Lights green
• Standby mode ·······························Lights red
• Power "OFF" ·································Indicator off
r
Power operation switch (POWER ON/OFF)
• Set this switch to "ON" to turn on power.
• Set this switch to "OFF" to turn off power.
t
Power cord
Connections
When connecting the speakers to an amplifier, be sure to read the
amplifier's owner's manual carefully and connect properly.
q
Speaker connections
w
(SC-F1312, SC-C1312)
• Connect the input terminals on the rear panel of the speaker with
the speaker output terminals on the amplifier, using the included
speaker cables.
e
• Labels on the back of each speaker are marked "
SL
"
". Connect each speaker to the following amplifier terminals. Be
sure to connect each speaker with correct polarity (+, –).
FR
•
To the amplifier's front-right speaker terminal.
r
FL
•
To the amplifier's front-left speaker terminal
C
t
•
To the amplifier's center speaker terminal
SR
•
To the amplifier's surround-right speaker terminal.
SL
•
To the amplifier's surround-left speaker terminal.
Amplifiers have various speaker output terminals.
Check the owner's manual of the amplifier you are using for details.
NOTE
• Be sure to turn the amplifier's power off before connecting the
speakers to the amplifier.
• If the polarities are inverted, the phase may be off and the sound
may have no bass component, making it seem unnatural. Be sure
to connect the polarities properly.
Connecting the speaker cables
Black : "–" (negative)
Black cable
FR
FL
C
SR
", "
", "
", "
",
1
Peel off the sheath from the tip of
the speaker cable, then firmly twist
the wires by hand so that they do not
stick out and cause short-circuits.
2
Press and lower the lever, and insert
the cable's core wire into the hole.
3
Release the lever.
Gently pull on the speaker cable to
check that it is firmly connected.
Once connections are completed, pull gently on the speaker cables
to check that they are securely connected.
NOTE
Do not let the core wires of two speaker cables touch each other.
Doing so will short-circuit the amplifier circuitry and damage the
amplifier.
ENGLISH
Red : "+" (positive)
Black with
white line cable
Lever
3
Hide quick links:
Advertisement
Table of Contents
