Contents
Distorted sound from the HEOS HomeCinema
If the signal source is a volume-controlled output, turn it down a couple of steps from maximum.
0
Check the signal source to be sure the distortion is not originating there.
0
If HEOS HomeCinema's volume is set to its maximum, turn it down a few steps.
0
Trouble teaching HEOS HomeCinema remote control commands
Remember that while HEOS HomeCinema can learn almost all IR (infrared) remote commands, there remain a few rare code
formats that cannot be taught (much like some engineers we know).
Television speakers keep getting turned back up
Disable the television's speakers (usually a setup-menu option, but a rear-panel switch on some televisions). If this is not possible,
the problem is likely that the television responds to press-and-hold (ramping) volume commands more quickly than the HEOS
HomeCinema; in this rare case use HEOS HomeCinema's front-panel or supplied remote to turn the HEOS HomeCinema's
volume up.
Setup
Use
Solution
Solution
Solution
Troubleshooting
63
Status LED
Appendix
Refer to Page
Refer to Page
Refer to Page
-
-
-
–
–