Page 1
● Remove all wrapping materials, including staples & packing straps before you start to assemble. ● Do not tighten all screws/bolts until completely assembled. ● Keep all hardware parts out of reach of children. Any problems or questions call Regency Office Furniture at 1-866-816-9822...
Page 2
Supports(D) and Back Supports(C). Finally, attach the Foot Brackets(B) and Top Brackets(A) to the Front Supports(D) and Back Supports(C)with 4 Bolts(O) per Leg. NOTE: Do not tighten bolts until all bolts have been started. Modesty Holes Figure 1 Left Leg Right Leg (interior side) (interior side) Any problems or questions call Regency Office Furniture at 1-866-816-9822...
Page 3
Be sure there is no gap between the modesty and the top. If so, loosen Bolts(O) and adjust. DO NOT ATTACH TO THE TOPS. (N,O) Right Bridge Left Bridge Any problems or questions call Regency Office Furniture at 1-866-816-9822...
Page 4
& left/right sides. Connect the End Legs and Corner Legs(G) to the tops as figure 1 and 2 depict. For extra support connect the Short Modesties(J) to the table top using 2 Screws(Q) each modesty. Bottom Figure 1 Right Left Figure 2 Any problems or questions call Regency Office Furniture at 1-866-816-9822...
Page 5
STEP 10: Reconnect the Long Modesty(I) to the Corner Legs(G) using 2 Bolts(O) and 2 Washers(N) each leg. Place the Short Top(L) in position and attach to Flat Brackets(H) using 12 Screws(Q) 6 screws each bracket. For extra support connect the Modesty(I) to the table top using 2 Screws(Q). Any problems or questions call Regency Office Furniture at 1-866-816-9822...