Advertisement
MUDS663042, MUDS663048, MUDS723042, MUDS723048 - INSTRUCTIONS
STEP 4A: Snap the Interior Leg Cover(F) into Back Support(C) and Front Support(D) using a rubber mallet.
NOTE: Interior Leg Cover is installed on the side with the modesty holes.
STEP 4B: Snap the Exterior Leg Cover(E) into Back Support(C) and Front Support(D) using a rubber mallet. The assembled legs
will now be referred to as the End Legs.
D
THE FOLLOWING STEP INCLUDES BOTH RIGHT AND LEFT ORIENTATIONS.
THE REMAINING STEPS ARE THE SAME NO MATTER THE ORIENTATION.
STEP 6: Choose your desk orientation and place the 30" Deep Long Table Top(K), 24" Deep Long Table Top(M), and Short Table
Top(L) on a clean flat surface with desired table finish face down so the sides of the three tops are flush on the long "connecting" side.
Connect an End Leg to one Short Modesty(J) with 2 Bolts(O) and 2 Washers(N) ensure the lip of the modesty is facing toward the
Short Top(M). Then Connect the opposite end of the Short Modesty(J) to 1 Corner Leg(G) with 2 Bolts(O) and 2 Washers(N) as
shown below. Be sure there is no gap between the modesty and the top. If so, loosen Bolts(O) and adjust. DO NOT ATTACH TO THE
TOPS.
J
O/N
M
Any problems or questions call Regency Office Furniture at 1-866-816-9822
Modesty Holes
F
C
NOTE : PRODUCT IS REVERSIBLE.
G
Right Bridge
L
K
C
(N,O)
Left Bridge
K
E
D
J
G
O/N
L
M
Advertisement
