Hilti WSR 36-A Original Operating Instructions page 26

5. Release the contact shoe adjustment button.
6. Grip and pull the contact shoe to check that it is locked in position.
5.6 Adjusting the stroke rate
Note
Please refer to the application table for the recommended stroke rate settings.
1. Set the stroke rate to a setting between 1 (low) and 6 (high) by turning the stroke rate regulator.
2. Press the control switch.
Note
The power tool will then run at the preselected stroke rate.
5.7 Pipe-cutting adapter (accessory)
1. Engage the transport lock.
2. Remove the saw blade.
3. Press the contact shoe adjustment button and hold it in this position.
4. Pull the contact shoe forward, away from the power tool.
5. Push the pipe-cutting adapter onto the front end of the power tool and bring it into the desired position.
6. Release the contact shoe adjustment button.
7. Grip and pull the pipe-cutting adapter to check that it is locked in position.
8. Release the screw clamp on the pipe-cutting adapter fully.
9. Place the chain around the pipe and hook it back onto the pipe-cutting adapter.
Note
The clamping screw should lie at an angle of 45° to the power tool.
10. Close the clamping screw.
5.8 Inserting the battery
WARNING
Electrical hazard! Risk of short circuiting.
▶ Before inserting the battery, check to ensure that the battery terminals and the contacts on the
reciprocating saw are free from foreign objects.
WARNING
Risk of injury! Hazard presented by a falling battery.
▶ A falling battery may present a risk of injury to yourself and others. Check that the battery is
securely seated in the reciprocating saw.
▶ Push the battery into the product from the rear as far as it will go and until it is heard to engage with a
double click.
5.9 Switching on
1. Disengage the transport lock.
2. Press the control switch.
5.10 Switching off
WARNING
Risk of injury! Caused by the saw continuing to run.
▶ Do not lift the product away from the workpiece until it has stopped completely.
▶ Wait until the product stops completely before you lay it down.
1. Release the control switch.
20 English
Printed: 30.05.2017 | Doc-Nr: PUB / 5071396 / 000 / 04
7
8