Table of Contents
Advertisement
•
When fully mated the lip seal will not be visible, and connection should look like as shown
in Figure 24
•
If the lip seal can still be seen, remove and retry making connection by following the
procedure again.
•
If connectors can't be mated both the plug and receptacle need to be inspected for any mis-
alignment damage or debris that is preventing connection.
•
If any damage has occurred, please contact Siemens Energy Technical Support for advice.
ROV connector maximum misalignment values and mating forces
Refer to section 5.1
Unrestricted
Figure 24
Alignment marks and lip seal mating indicator
Document No: IOM-002
Issue Date:
24/09/2020
Revision:
6
Page:
38 of 42
Hide quick links:
Advertisement
Table of Contents
