No Encryption; Wep Encryption; Figure 10 Wizard 4: Wireless Lan Setup: Wep Security; Table 9 Wizard 4: Wireless Lan Setup: Wep Security - ZyXEL Communications ZyXEL Prestige P-330W User Manual

3.4.1 No Encryption

Choose None to allow the WLAN to operate without encryption. Warning: With no
encryption enabled anyone will be able to access your network and view any data you send
over the wireless LAN.

3.4.2 WEP Encryption

Choose WEP to setup WEP Encryption parameters.

Figure 10 Wizard 4: Wireless LAN Setup: WEP Security

The following table describes the labels in this screen.

Table 9 Wizard 4: Wireless LAN Setup: WEP Security

LABEL
Key Length
Key Format
Default Tx Key This key refers to which key below will be used as the default key.
Key 1 to Key 4 The WEP keys are used to encrypt data. Both the P-330W and the wireless stations
Chapter 3 Wizard Setup
DESCRIPTION
Select 64-bit WEP or 128-bit WEP data encryption.
Select ASCII in order to enter ASCII characters as the WEP keys.
Select Hex to enter hexadecimal characters as the WEP keys.
must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal
characters ("0-9", "A-F").
You must configure at least one key, only one key can be activated at any one time.
The default key is key 1.
ZyXELP-330W User's Guide
36