Static Route Setup - ZyXEL Communications Prestige 645R User Manual

FIELD
Multicast IGMP (Internet Group Multicast Protocol) is a session-layer
protocol used to establish membership in a Multicast group. The
P645R supports both IGMP version 1 (IGMP-v1) and version 2
(IGMP-v2). Press the [SPACE BAR] to enable IP Multicasting or
select None (default) to disable it.
IP Policies You can apply up to four IP Policy sets (from twelve) by entering
their numbers separated by commas.
VPI (VC –based Enter the Virtual Path Identifier (VPI) number that your telephone
ENET ENCAP company supplies.
and RFC 1483)
VCI (VC –based Enter the Virtual Channel Identifier (VCI) number that your
ENET ENCAP telephone company supplies.
and RFC 1483)
Once you have completed filling in the Network Layer Options Menu, press [ENTER] to return to menu 11.
Press [ENTER] at the message [Press ENTER to Confirm...] to save your configuration, or press [ESC] at
any time to cancel.

5.1.2 Static Route Setup

Static routes tell the Prestige routing information that it cannot learn automatically through other means.
This can arise in cases where RIP is disabled on the LAN or a remote network is beyond the one that is
directly connected to a remote node. Each remote node specifies only the network to which the gateway is
directly connected, and the Prestige has no knowledge of the networks beyond.
For instance, the Prestige knows about network N2 in the following diagram through remote node Router 1.
However, the Prestige is unable to route a packet to network N3 because it doesn't know that there is a
route through remote node Router 1 (via Router 2). The static routes are for you to tell the Prestige about
the networks beyond the remote nodes.
Remote Node TCP/IP Configuration
Prestige P645 ADSL Internet Access Router
DESCRIPTION EXAMPLE
None
(default)
3,4,5,6
0
35
5-7