Pre-Set Power Center Mount Legrest - Sunrise Medical QUICKIE Sedeo Pro Instructions For Use Manual

4.10 Pre-set power center mount legrest

DANGER! / WARNING!
• Be aware of your environment to make sure you do not injure
your legs when Leg Rests are extended.
• Always ensure that the Leg Rests or foot plates do not come into
contact with the castors before driving the wheelchair.
• Leg Rests are not to be used for lifting or carrying the wheelchair
under any circumstances.
• As with all moving parts be careful not to trap your fingers,
(Fig.4.39).
Lower leg length (Fig 4.40)
The power centre mount legrest allows angle adjustment from 90°
to 180° level to ground and a 180 mm powered length extension.
1. Loosen (A) by one turn.
2. Adjust (B) to the desired position.
3. Tighten (A).
4. Repeat for the other side.
NOTE / CAUTION!
In case of optional 'Footplate to the floor' function (Fig. 4.41), a
switch is mounted. The switch (A) needs to be adjusted in height
after adjusting the lower leg length. Make sure the ball of the
switch is completely under the lowest edge of the footrest (B).
Ankle angle (Fig 4.42)
1. Flip up (A).
2. Turn (B) in order to adjust the ankle angle as desired
(4 mm Allen key)
3. Fold (A) down.
DANGER! / WARNING!
• After adjustment and with the seat in its normal drive position:
Ensure there Is a gap of, (>25 mm.), between the floor and the
footplate at all times.
• Perform this test with the user sitting in the chair loading the leg
rest.
Using the chair with the leg rest set too low might result in
personal injury or damage to the wheelchair and its surroundings.
Calf pad height (Fig 4.43)
1. Loosen (A) by one turn.
2. Adjust (C) to the desired position.
3. Tighten (A).
Calf pad width (Fig 4.43)
4. Loosen (B) by one turn.
5. Adjust (C) to the desired position.
6. Tighten (B).
Sedeo Pro Rev.B
1m
A
2
B
A
B
A
1
B
C
2
B
A
Fig. 4.39
Fig. 4.40
M5
1
M5
3
Fig. 4.41
Fig. 4.42
2 M4
Fig. 4.43
5
M5
1 4
3 6 M5
19