Husqvarna T540 XP Workshop Manual page 48

Repair instructions
6
Loosen the two lower screws holding the oil pump
cover. See figure 60.
7
Loosen the four screws holding the intake system.
See Figure 61.
8
The intake plate is fastened to the cylinder cover
using the hooks (one on each side). See Figure 62.
8
Loosen the oil pump cover from its groove and
carefully remove the cylinder cover with the intake
system. See Figure 63.
Cleaning and checking
Clean and check all parts carefully. Parts must be
replaced if cracked or show signs of other defects.
Always use original spare parts.
48
– English
Fig 60
Fig 61
Fig 62
Fig 63