Assembling The Centrifugal Clutch; Dismantling The Oil Pump And Screen - Husqvarna T540 XP Workshop Manual

7.10 Assembling the centrifugal clutch

1
Hook the springs into the clutch shoes using a
pliers. See Figure 27.
2
Screw in the clutch (anti-clockwise) until it stops.
Then tighten the clutch using tool 502 54 16-02
and a suitable socket spanner. Tightening torque of
20 Nm. See Figure 24 "Dismantling the centrifugal
clutch".
3
Remove the piston stop and fit the spark plug and
spark plug cap. Tightening torque for the spark
plug is 18-20 Nm.
4
Assemble the air filter cover, saw bar, saw chain
and clutch cover.
7.11 Dismantling the oil pump and
screen
1
Empty and clean the oil tank.
Dismantle the centrifugal clutch. See the
"Dismantling the centrifugal clutch" chapter.
Dismantle the clutch drum and the needle bearing.
See Figure 28.
2
Loosen the screws as outlined in Figure 29 and
remove the oil pump cover.
3
Remove the chain guide plate (A) and the pump
drive wheel (D). See Figure 30.
4
Loosen the screws for the oil pump as outlined
in Figure 31 and remove it together with the oil
pressure hose.
Fig 27
Fig 28
Fig 29
Fig 30
Fig 31
Repair instructions
37
English –