Figure 1 Wds Functionality Example - ZyXEL Communications ZyXEL ZyAIR G-570S User Manual

ZyXEL G-570S User's Guide

Figure 1 WDS Functionality Example

OTIST (One-Touch Intelligent Security Technology)
OTIST allows your G-570S to assign its SSID and security settings (WEP or WPA-PSK) to
the ZyXEL wireless adapters that support OTIST and are within transmission range. The
ZyXEL wireless adapters must also have OTIST enabled.
10/100M Auto-negotiating Ethernet/Fast Ethernet Interface
This auto-negotiating feature allows the G-570S to detect the speed of incoming transmissions
and adjust appropriately without manual intervention. It allows data transfer of either 10 Mbps
or 100 Mbps in either half-duplex or full-duplex mode depending on your Ethernet network.
10/100M Auto-crossover Ethernet/Fast Ethernet Interface
The LAN interface automatically adjusts to either a crossover or straight-through Ethernet
cable.
Reset Button
The G-570S reset button is built into the rear panel. Use this button to restart the device or
restore the factory default password.
802.11g Wireless LAN Standard
The ZyXEL wireless products containing the letter "G" in the model name, such as G-570S
and G-162, comply with the IEEE 802.11g wireless standard.
IEEE 802.11g is fully compatible with the IEEE 802.11b standard. This means an IEEE
802.11b radio card can interface directly with an IEEE 802.11g access point (and vice versa) at
11 Mbps or lower depending on range.
Wi-Fi Protected Access
Wi-Fi Protected Access (WPA) is a subset of the IEEE 802.11i standard. Key differences
between WPA and WEP are user authentication and improved data encryption.
22 Chapter 1 Getting to Know Your G-570S