Note: The wireless stations and G-570S must use the same SSID, channel and
wireless security settings for wireless communication.
If you do not enable any wireless security on your G-570S, your network traffic
is visible to any wireless networking device that is within range.
2.4 Restarting the G-570S
Press and immediately release the RESET button to restart the G-570S.
Note: Holding the RESET button in for five seconds or longer resets the device to the
factory-default settings.
2.5 Resetting the G-570S
If you forget the G-570S's IP address or your password, to access the G-570S, you will need to
reload the factory-default using the RESET button. Resetting the G-570S replaces the current
configuration file with the factory-default configuration file. This means that you will lose all
configurations that you had previously. The following parameters will be reset to the default
values.
Table 2 Factory Defaults
PARAMETER
IP Address
Password
Wireless Security
SSID
2.5.1 Methods of Restoring Factory-Defaults
You can erase the current configuration and restore factory defaults in two ways:
1 Use the RESET button on the G-570S to upload the default configuration file (hold this
button in for at least five seconds).
2 Use the web configurator to restore defaults. Click SYSTEM > Management >
Configuration File. From here you can restore the G-570S to factory defaults.
Chapter 2 Management Computer Setup
DEFAULT VALUE
192.168.1.2
1234
Disabled
ZyXEL G-570S
ZyXEL G-570S User's Guide
33