ZyXEL G-570S User's Guide
Hold in the OTIST button for one or two seconds.
6.17.1.1.2 Web Configurator
Click WIRELESS > SETTINGS > OTIST to configure and enable OTIST. The screen
appears as shown.
Note: At the time of writing the device does not support OTIST in the wireless client
mode.
Figure 53 OTIST
The following table describes the labels in this screen.
Table 23 OTIST
LABEL
One-Touch Intelligent Security Technology
Setup Key
Yes!
Start
6.17.1.2 Wireless Client
Start the ZyXEL utility and click the Adapter tab. Select the OTIST check box, enter the
same Setup Key as your AP's and click Save.
90
DESCRIPTION
Enter the setup key of up to eight printable characters. The default OTIST setup
key is "01234567".
Note: If you change the OTIST setup key here, you must also make
the same change on the wireless client(s).
To have OTIST automatically generate a WPA-PSK key, select this check box. If
you manually configured a WEP key or a WPA-PSK key and you also select this
check box, then the key you manually configured is used.
Click Start to encrypt the wireless security data using the setup key and have the
device set the wireless client to use the same wireless settings as the device. You
must also activate and start OTIST on the wireless client at the same time.
The process takes three minutes to complete.
Chapter 6 Wireless Screens