Wds Profile Commands; Wds Profile Example - ZyXEL Communications nwa series Reference Manual

8.7 WDS Profile Commands

The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
Table 31 Input Values for General WDS Profile Commands
LABEL
wds_profile_name
The following table describes the commands available for WDS profile managment. You must use
the
configure terminal
commands.
Table 32 Command Summary: WDS Profile
COMMAND
show wlan-wds-profile {all | rule_count |
[wds_profile_name]}
wlan-wds-profile rename wds_profile_name1
wds_profile_name2
[no] wlan-wds-profile wds_profile_name
psk psk
ssid ssid
exit

8.7.1 WDS Profile Example

The following example creates a WDS profile with the name 'WDS1', and shows the profile settings.
Router(config)# wlan-wds-profile WDS1
Router(config-wlan-wds WDS1)# ssid ZyXEL-WDS
Router(config-wlan-wds WDS1)# psk qwer1234
Router(config-wlan-wds WDS1)# exit
Router(config)# show wlan-wds-profile WDS1
wds profile: WDS1
reference: 0
Id: 2
Description:
WDS_SSID: ZyXEL-WDS
WDS_PSK: qwer1234
Router(config)#
NWA/WAC Series CLI Reference Guide
DESCRIPTION
The WDS profile name. You may use 1-31 alphanumeric characters,
underscores ( ), or dashes (-), but the first character cannot be a number. This
_
value is case-sensitive.
command to enter the configuration mode before you can use these
DESCRIPTION
Displays the WDS profile(s) settings.
all: Displays settings of all WDS profiles configured on the NWA/
WAC.
rule_count: Displays how many WDS profiles are created on the
NWA/WAC.
wds_profile_name: Displays settings of the specified profile.
Gives the existing WDS profile (wds_profile_name1) a new
name, (wds_profile_name2).
Enters configuration mode for the specified WDS profile.
Sets a pre-shared key of between 8 and 63 case-sensitive ASCII
characters (including spaces and symbols) or 64 hexadecimal
characters.The key is used to encrypt the traffic between the APs.
Sets the SSID with which you want the NWA/WAC to connect to a
root AP or repeater to form a WDS.
Exits configuration mode for this profile.
Chapter 8 Wireless LAN Profiles
63