Setting Up The Machine; Setup And Transporting Precautions - Brother PR1055X Operation Manual

30. Magnetic frame
50 mm (W) x 50 mm (H)
(2 inches (W) x 2 inches (H))
PRMH50 (Americas)
PRMF50: XG8597-001 (Europe)
PRMF50AP: 115D02E700F (other areas)
31. Scan frame set
PRSCANFKIT1: XG8237-001 (Europe)
PRSCANFKIT1AP: 115D02E700D (other
areas)
32. Tubular frame table
PRTT1 (Americas)
PRTT1: D01FAF-001 (Europe)
PRTT1AP: 115K02E7002 (other areas)
33. Embroidery Stand
PRNSTD2 (Americas)
VRPRNSTD: XG3199-001 (Europe)
VRPRNSTDCN: 115Z05E6005 (China)
VRPRNSTD: 115Z05E7005 (other areas)
34. Metal bobbin
100376-051
35. Weight (S)
XC6631-051
36. Embroidery positioning sticker sheets
× 8
SAEPS2 (U.S.A.) / SAEPS2C (Canada)
EPS2: XG6749-001 (Europe)
EPS2CN: 115Z05E600E (China)
EPS2: 115Z05E700E (other areas)
Note
• Visit your nearest authorized Brother dealer for a
complete listing of optional accessories and
embroidery cards available for your machine.
Memo
• Always use accessories recommended for this
machine.
• All specifications are correct at the time of printing.
Please be aware that some specifications may
change without notice.
16
Part Name
Part Code

SETTING UP THE MACHINE

Setup and transporting precautions

CAUTION
• The temperature of the operating environment
should be between 5 °C (40 °F) and 40 °C
(104 °F). If the machine is operated in an
environment that is either too cold or too hot,
the machine may malfunction.
• Do not use the machine in a location where it
will be exposed to direct sunlight, otherwise
the machine may malfunction.
• Set up the machine with it's four adjustable
feet completely in contact with the desk or
table, so that the machine is level.
• Do not put anything under the machine that
could block the ventilation slots found on the
rear underside of the machine, in order to
avoid the possibility of the machine's motor
overheating, resulting in a fire or in damage to
the machine.
• The machine weight is approximately 41.8 kg
(92 lb). The transporting or setting up of the
machine should be performed by two people.
• When transporting the machine, be sure to
have two people lift the machine from the
bottom at the indicated slots (1). Lifting the
machine from any other area may damage the
machine or result in the machine falling, which
could cause injuries.
• When lightning occurs, turn off the machine
and unplug the power supply cord. Lightning
may cause the machine to malfunction.
• Do not plug in the power supply cord until
setup of the machine is completed, otherwise
injuries may result if the "Start/Stop" button is
accidentally pressed and the machine starts
embroidering.