Bowflex TreadClimber TC6000 Assembly Manual & Owner's Manual page 26

assembly Process
Figure 8: Attaching Power Cord
Failure to visually check and test assembly
before use can cause damage to the Bowflex®
TreadClimber® fitness machine, serious injury to
users and bystanders, and can also compromise
the effectiveness of your exercise program.
ASSeMBLY GUIDe

Step 8: Attaching Power Cord
Locate the following for this step:
Parts:
• Assembly from Step 7
• Power Cord
8-1 Locate the power cord.
8-2 Attach the power cord to the AC Inlet on the front
of the TreadClimber® fitness machine base frame.
NOTE: Wall outlet must be
AC Inlet
Step 9: Inspecting Final Assembly
Congratulations!
Now that you have assembled your Bowflex®
TreadClimber® fitness machine, it is VERY
IMPORTANT to tighten all screws and bolts, and
visually inspect the unit. If your TreadClimber®
fitness machine sits unevenly you may adjust
the rear feet with a wrench to make the exercise
machine stable on your floor. Make sure that your
TreadClimber® fitness machine has been assembled
correctly and securely, and that there are no loose or
unattached parts prior to using the machine.
a non-GFI protected circuit,
within reach of the power cord.