Maintenance - Royal Azury Operating Manual

Cylinder vacuum cleaner
Table of Contents

Advertisement

Available languages

Available languages

3 Maintenance

3.1 Overview of the filters
17
3.2 Cleaning / changing the motor protection filter
18
A
D
19
3.3 Cleaning / changing the exhaust filter
20
21
3.4 Accessories and Spare
Parts
3.5 Sources
3.6 Recommendation
12
3
Maintenance
The filters may get dirty with time and therefore must be checked regularly.
The following filters are installed:
Motor protection filter (Fig. 17/1)
It prevents larger particles from destroying the motor in case the dust filter bag is defective.
- Changing: after each 5th change of the dust filter bag, at least every 6 months (Zchapter 3.2, „Cleaning
/ changing the motor protection filter").
Exhaust filter (Fig. 17/2)
The exhaust filter unit filters finest particles from the exhaust airstream.
- Changing: every 6 months (Zchapter 3.3, „Cleaning / changing the exhaust filter").
1. Switch off the appliance and remove the dust the filter bag, Zchapter 3.1, „Overview of the filters", steps 1–6.
2. Remove the motor protection filter by pulling it upwards out of its guiderails. (Fig. 18).
3. Hold the motor protection filter together with the holder over a dustbin.
4. Only then separate the motor protection filter from the filter holder.
5. Remove larger agglomerations of dirt by hand.
6. Then rinse the motor protection filter by hand thoroughly with clear cold water.
ATTENTION:
The motor protection filter is washable, but it may not be cleaned in dishwashers or washing-machines. Do not
use chemical cleansers to clean the filter. Then leave the motor protection filter to dry (approx. 24 hours at
B
room temperature). Only put it back into the appliance when it is completely dry.
7. If the motor protection filter is damaged or deformed, replace it with a new one (Zchapter 3.4, „Accessories
and Spare Parts").
8. Push the new/cleaned motor protection filter back into its filter holder (Fig. 19/A).
Make sure that the 4 tabs on the backside of the filter holder are now completely visible (Fig. 19/B1).
C
Accordingly, none of the 4 tabs must be visible when you look at the filter holder with the fitted motor
protection filter from the front side (Fig. 19/C).
9. Before refitting the filter holder with its fresh filter make sure that grille of the filter holder is facing the front
side (Fig. 19/C) and the arrow on the bottom edge of the filter is pointing downwards (Fig. 19/D).
10. Push the motor protection filter back into its guiderails.
11. Replace the dust filter bag and close the dust compartment cover. It clicks shut audibly.
1. Switch off the vacuum cleaner and pull the plug from the mains socket, Zchapter 2.3, „Switching off".
2. Push down the release catch of the exhaust filter cover and fold down the cover (Fig. 20).
3. Hold the exhaust filter cover complete with the exhaust filter over a dustbin.
4. Only now separate the exhaust filter from the exhaust filter cover (Fig. 21).
5. Remove larger agglomerations of dirt by hand.
6. Then rinse the exhaust filter element by hand thoroughly with clear cold water.
ATTENTION:
The exhaust filter is washable, but it may not be cleaned in dishwashers or washing-machines. Do not use
chemical cleansers to clean the filter. Then leave the exhaust filter to dry (approx. 24 hours at room
temperature). Only put it back in place when it is completely dry.
7. If the exhaust filter is damaged or deformed, replace it with a new one (Zchapter 3.4, „Accessories and
Spare Parts").
8. Put the clean/new exhaust filter back into the exhaust filter cover.
The exhaust filter's correct position is determined by its shape.
9. First hook the exhaust filter cover with the fresh filter in at the bottom side and then press the upper side
towards the housing until you feel it snap into place (Fig. 20).
Item number
7010022
Set of 5 dust filter bags and 1 motor protection filter
7099002
1 exhaust filter
Ordering address Zpage 65, „International Service".
Further information is available at http://www.dirtdevil.de
£
We recommend: Swirl
NOTE:
Insert the bag in direction "A."
Swirl
, MicroPor
and "Y05" are registered trade marks of a company of the Melitta group and used with their permission.
Description
Y05 dust filter bags with MicroPor
Item number
M203
1 parquet brush
M209
1 turbo brush
£
filtration.
Description

Advertisement

Table of Contents
loading

This manual is also suitable for:

M7099

Table of Contents