Husqvarna TC 250 2012 Specifications - Operation - Maintenance page 60

THROTTLE CABLE ADJUSTMENT
To check the correct adjustment of the throttle operate as fol-
lows:
- Remove rubber caps (1);
- by moving the opening cable (2) back and forth, check that
free play is 3 mm;
- by moving the closing cable (3) back and forth, check that
free play is 1 mm;
- if it does not happen, loosen the nut (4) and appropriately
turn the adjuster screw (5);
(loosen it to decrease clearance, tighten it to increase it);
- after adjustment block the nut (4).
WARNING*: Operation with damaged throt-
tle cable could result in an unsafe riding con-
dition.
WARNING*: Exhaust gas contains poisonous
carbon monoxide gas. Never run the engine
in a closed area or in a confined area.
4
5
4
5
EN - 18 SPECIFICATIONS - OPERATION - MAINTENANCE
ADJUSTING THE IDLE
Adjust the carburetor with warm engine and with the throttle
control in closed position. Proceed as follows:
- turn the knob (1) on the right side of the throttle body of
about 34 clicks from the fully closed position, checking with
the suitable device that revs are of about 1,950 RPM (turn
clockwise to increase the speed and counter clockwise to re-
duce it).
2
3
1
1