Husqvarna TC 250 2012 Specifications - Operation - Maintenance page 56

STOPPING THE MOTORCYCLE AND THE ENGINE
- Close the throttle (1) completely so that the engine will help
slow down the motorcycle.
- For normal braking, gradually apply both front and rear
brakes while down shifting (for maximum deceleration, apply
the front and rear brakes firmly).
- When stopped, pull the clutch lever and shift gear lever (2) in
neutral position.
1
2
EN - 14 SPECIFICATIONS - OPERATION - MAINTENANCE
- Press the engine stop RED button (3).
WARNING*: Independent use of the front or
rear brake may be advantageous under cer-
tain conditions. Use caution when using the
front brake, especially on slippery surfaces.
Improper use of the brakes can lead to a se-
rious crash.
WARNING*: In the event of stuck throttle or
other malfunction which causes the engine to
run uncontrollably, immediately depress the
engine stop button and hold it down. Control
the motorcycle by normal use of the brakes
and steering while holding the engine stop
button down.
3
CHECKING THE OIL LEVEL
Keeping the motorbike level and in a vertical position, check the
oil level through the inspection (1) window on the right crankcase.
Make sure the level is in between the MIN and MAX notches.
To fill up, remove the filler cap (2).
Note*: Have this operation made with
warmed-up engine.
WARNING*: Be careful not to touch hot en-
gine oil.
1
2
a