Kohler K-6918 Installation And Care Manual page 5

Finished Wall
Outlet Hole
2. Mark the Pipes - Wall Side
Remove and discard the plaster guards from the inlet and outlet
holes.
Apply silicone plumbers grease to the gasket in the opening of
the inlet and outlet holes.
Firmly insert the inlet pipe completely into the inlet hole.
NOTE: If the finished wall aligns with any portion of the gasket
section of the inlet pipe, no mark or cut is required.
Use a level or other straight edge to mark the inlet pipe even
with the front edge of the finished wall.
Firmly insert the outlet pipe completely into the outlet hole.
NOTE: If the finished wall aligns with the wide part of the outlet
pipe, no mark or cut is required.
Use a level or other straight edge to mark the outlet pipe even
with the front edge of the finished wall.
Remove the inlet and outlet pipes.
Kohler Co.
Inlet Hole
Inlet Pipe
Outlet Pipe
5
Plaster
Guard
1287824-2-A