Kohler K-6918 Installation And Care Manual page 10

7. Install the Bowl
NOTE: This step is easier when performed by two people.
NOTE: Be sure all gaskets are well lubricated with silicone
plumbers grease. Reapply grease if necessary.
Confirm the gasket on the inside of the inlet elbow has correctly
engaged with the inlet pipe.
Confirm the gasket on the inside of the outlet elbow has correctly
engaged with the outlet pipe.
Carefully lift the bowl up and align the threaded rods and pipes
with the corresponding holes.
Make sure the pegs are oriented with the notches facing down.
Slide the bowl onto the threaded rods, inlet pipe and outlet pipe.
Make sure the bowl fully engages the gaskets on the inlet and
outlet pipes.
Slide the bowl back until it makes contact with the wall.
From the underside of the bowl, attach the tool to the hex shaft
and turn counterclockwise to secure the bowl.
1287824-2-A
Notch
10 Kohler Co.