Paper Jams - Fuji Xerox ApeosPort 4570 Reference Manual

Paper Jams

If paper is jammed, the machine stops and an alarm sounds. A message also appears on the touch panel dis-
play. Follow the instructions displayed to remove the jammed paper.
Gently remove the paper being careful not to tear it. If paper is torn while it is being removed from the
machine, remove all the torn pieces making sure that none remain inside the machine.
When you have finished clearing the paper jam, printing is automatically resumed from the state before the
paper jam occurred. If a paper jam occurred during copying, tap on [Start]. Copying is resumed from the
state before the paper jam occurred.
Note If a paper jam occurred, check the paper jam position before pulling out a paper tray.

Clear the paper jams while the machine is on.

Do not touch components inside the machine. This may cause print defects.

Side Tray
1.
Remove the jammed paper.
Inside Upper Left Cover
The fusing unit is extremely hot. Do not touch the fusing unit as it may result in a burn injury.
Important
Do not touch the machine-side transfer belt (black film-like belt) inside the upper left cover when you
remove the jammed paper. The image quality may be deteriorated or the transfer belt may be damaged
and need replacement.
1.
While lifting up the release lever, open the upper left
cover.
Note When the Side Tray is installed, remove the paper

in the Side Tray, close the Side Tray, and then open
the upper left cover.
When HCF (1 tray) is installed, hold the handle and

fully move the unit to the left.
Warning
-39-
iv Problem Solving