Johnson Controls S300 Series Hardware Installation Manual page 14

Hardware Installation
B B
ACKUP ATTERIES
Battery Bracket Kit (S300-DIN-BRK)
The S300-DIN-BRK is a battery bracket kit used to mount the batteries in the
enclosure. The same kit is used for small and large enclosures, and, depending on
your installation, you will need only some of the parts that are included.
The batteries and bracket kit are sold separately and the batteries can be replaced
without ordering an additional kit.
Each kit contains the following:
Two brackets

Mounting hardware

Short battery wiring (used with small enclosures only)

Long battery wiring (used with large enclosures only)

S300-DIN battery wiring

Two adhesive cable tie mounting pads

Two cable ties

S300-DIN
battery wiring
10
Short and long Cable ties
battery wiring
Figure 3: Battery Bracket Kit
This document contains confidential and proprietary information of Johnson Controls
S300-DIN-L
Brackets
Mounting
hardware
Adhesive
cable tie
mounting
pads
24-10239-340 Rev. B
© 2017 Johnson Controls