Calibrating Cala Trio - Cala Health Cala Trio CT1-STR Health Care Professional Manual

•
Should be snug enough so it does not slide along or
around the wrist.
Left Handed
Device
Electrode
•
The electrodes should be flush to the skin.

5.2 Calibrating Cala Trio

During stimulator setup, Cala Trio learns about
your tremor and personalizes therapy according
to its characteristics.
•
Calibration happens over the course of three
measurements taken while you perform the
"Tremor Task" prescribed by your physician.
Determine your "Tremor Task" by checking your
Before calibrating, determine your "Tremor Task" by
prescription information.
checking your prescription information
Note: In order to conserve battery, Cala Trio goes into
SLEEP mode and fades to black if you are not actively
pressing any buttons. Press any button to wake
up Cala Trio.
UP
button
DOWN
button
Step 1: Press the MAIN button to wake up the stimulator.
You should see Cala Trio displayed
LBL-5122 Rev C NOV 2019
Right Handed
Device
Electrode
™
MAIN
button
Questions about Cala Trio? Visit CalaTrio.com/HCPFAQs
Step 2: From Cala Trio, press and hold the MAIN button for
3 seconds to start setup. You will see "press main
to measure 1"
Outstretched
postural hold
Step 3: Get in position to do your "Tremor Task"
(see above) You can find your "Tremor Task" in
your prescription information
Step 4: Press the MAIN button to start the measurement
Step 5: Perform your "Tremor Task" until all dots are
blue (~20 seconds). Cala Trio will vibrate when the
"Tremor Task" is complete
Step 6: If you correctly performed your "Tremor Task" for
the full measurement, press the MAIN button to
save the measurement
Note:
If you were moving in a way unrelated to your
tremor during the "Tremor Task", like walking or talking,
press the DOWN button and then the MAIN button to
remeasure.
OR
Wing-beating
postural hold
9