Caring For Cala Trio; How To Charge Cala Trio; How To Replace Cala Trio Band; How To Change Stimulation Intensity Preset - Cala Health Cala Trio CT1-STR Health Care Professional Manual

7.0

CARING FOR Cala Trio™

View instructional videos at my.CalaTrio.com

7.1 How to Charge Cala Trio

Charge Cala Trio
•
Overnight
•
With band attached to the stimulator
Note: The band must be attached to the stimulator in
order to charge.
status light
Step 1: Place the stimulator with the band attached into
the base station
» Cala Trio displays that it is charging and then fades to
sleep after a few seconds.
» The base station will also communicate its status via a
light. The table below shows the status light options:
white light
device connecting, ready to charge
green light
charging
device updating , do not remove
yellow light
from base station
red light
replace Cala Trio Band
7.2 How to Replace Cala Trio
Cala Trio will display "replace band" in order to maintain
effective therapy.
Step 1: Check that the size and the handedness of the
band matches your prescription information.
LBL-5122 Rev C NOV 2019
™
™
Band
Questions about Cala Trio? Visit CalaTrio.com/HCPFAQs
Step 2: Remove the used band by unsnapping it
from the stimulator
Step 3: For the new one, align the half circle cut outs on
the back of the band and stimulator as you snap
them together
Step 4: Place the stimulator attached to the new band
in the base station for 15 seconds in order to clear
the "replace band" message
7.3 How to Change Stimulation
Intensity Preset
Change the preset if you would prefer a different
stimulation intensity for therapy.
Step 1: From the time display, press the UP or DOWN
buttons until you see "intensity setting". Press the
MAIN button
Step 2: Press the DOWN button to highlight 'reset.'
Then press the MAIN button
Step 3: Use the UP button to increase the therapy to an
appropriate level. See steps 2-3 in section 5.3 on
page 10 for more detail
Step 4: Press the MAIN button to stop the therapy. Then
press the MAIN button again to save the intensity.
You will now see the clock
1 3