Secure Owner's Approval; Normal Maintenance - York Sunline 2000 Installation Instruction

Single package heat pumps
Hide thumbs Also See for Sunline 2000:
Table of Contents

Advertisement

511.06-N5Y
WARNING: Failure to properly adjust the total system air quan-
tity can result in poor system performance.
After readings have been obtained, remove the tubes and seal
the drilled holes in the side panels. 5/16" dot plugs (P/N
029-13880) are available through normal parts ordering
procedures.
NOTE: DE-ENERGIZE THE COMPRESSORS BEFORE
TAKING ANY TEST MEASUREMENTS TO ENSURE
A DRY INDOOR COIL.
SECURE OWNER'S APPROVAL: When the system is functioning properly, secure the owner's approval. Show him the location
of all disconnect switches and the thermostat. Teach him how to start and stop the unit and how to adjust temperature settings
within the limitations of the system.

NORMAL MAINTENANCE

CAUTION: Prior to any of the following maintenance proce-
dures, shut off all power to the unit to prevent
personal injury.
FILTERS - Inspect once a month. Replace disposable or clean
permanent type as necessary. DO NOT replace permanent
type with disposable.
MOTORS - Indoor fan and outdoor fan motors are permanently
lubricated and require no maintenance.
14
0.5
0.4
0.3
0.2
0.1
0
1000
FIG. 10 - PRESSURE DROP ACROSS A DRY INDOOR
COIL VS. SUPPLY AIR CFM
MAINTENANCE
OUTDOOR COIL - Dirt should not be allowed to accumulate
on the outdoor coil surface or other parts in the air circuit.
Cleaning should be as often as necessary to keep coil clean.
Use a brush, vacuum cleaner attachment, or other suitable
means. If water is used to clean coil, be sure power to the unit
is shut off prior to cleaning.
NOTE: Exercise care when cleaning the coil so that the coil
fins are not damaged.
Do not permit the outdoor air discharge to be ob-
structed by overhanging structures of shrubs.
036
1500
2000
NOMINAL CFM
Unitary Products Group
048
060
2500
3000

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents