Table of Contents
Advertisement
●
[Changing delay] is the function to prevent the
accidental input switch during a short period, such as
when the signal is interrupted due to the frequency
change for the input signal while [Input detection] is
operating.
If a signal is detected again within the set period
(sec.), the input is not switched.
●
[Input detection] may not operate correctly depending
on the image playback device.
Note
●
When set to the USB input, the unit determines no
signal is present if the USB memory is not connected
to the USB terminal.
In addition, even when a USB memory is connected,
if there is no playable file, the unit determines no
signal is present.
●
This menu will be greyed out and cannot be set under
the following conditions.
[Failover/Failback] is set to the item other than
•
[Off]. (see page 84)
[Power management mode] is set to [Input
•
detection]. (see page 89)
[Input lock] is not set to [Off]. (see page 93)
•
When [Setup] - [Image settings] - [No signal image
•
settings] - [Display setting] is set to [On]. (see page
93)
[SLOT power link] is set to [On]. (see page 107)
•
●
If the input is changed by this function, the last input
is selected when the power is turned on next time.
If you wish to retain the original input when the power
is turned on, set [Initial input] to the original input.
(see page 82)
84
English
Failover/Failback
Automatically switches to the backup input if an
interruption of video occurs.
Note
●
MEMORY VIEWER / Screen Transfer /
WHITEBOARD input is excluded from this function.
1. Setting the input change mode
■
[Input change mode]
[Off]:
Disables the Backup Input function.
Failover/Failback
Input change mode
[Quick]:
Promptly switches to the backup input if an
interruption of video occurs.
The backup video signal needs to be in the same
format as the (main) input in use for viewing.
Upon switching to the backup input, the video and
audio adjustment values for the (main) input used
for viewing will be inherited.
Failover/Failback
Input change mode
Primary backup input
Secondary backup input
Auto switch back mode
Changing mode
Backup input change
Main input
Current input
[Normal]:
Switches to the backup input if an interruption of
video occurs.
The backup video signal does not need to be in the
same format as the (main) input in use for viewing.
Upon switching to the backup input, the video and
audio adjustment values for the backup input will
be used.
Off
Quick
HDMI1
HDMI2
Disable
High speed
Active
HDMI2
Main input
Advertisement
Table of Contents
