224
Send waypoint
Allows this unit to send a waypoint to other devices over the NMEA
2000 network.
A waypoint will be transmitted when the waypoint is created, if the
following settings are in place:
•
The sending device - the send waypoint option must be set to
ON before the waypoint is created.
•
The receiving device - the receive waypoint option must be set
to ON before the waypoint is created in the sending device.
Ú Note:
The system can only transmit or receive one waypoint at
a time over the NMEA 2000 network. For bulk export or import
of waypoints, refer to "Backing up your system data" on page 182. That
section describes how to export and import user settings, e.g.
waypoints.
Backlight synchronization
Select this option to allow display brightness synchronization across
display units connected to the same network.
System
setup| ELITE FS User Manual