Fuel Settings - Lowrance Elite FS 7 User Manual

Adjust local interference reject
Interference from some onboard sources can interfere with the
Broadband radar. One symptom of this could be a large target on
the screen that remains in the same relative bearing even if the
vessel changes direction.
Halo light
Controls the levels of the Halo Radar blue accent lighting. The
accent lighting can only be adjusted when the radar is in standby
mode.
Ú Note:
The blue accent pedestal lighting might not be approved
for use in your boating location. Check your local boating
regulations before turning the blue accent lights ON.
Reset radar to factory defaults
Clears all user and installer settings applied to the selected radar
source, and restores factory settings.
Ú Note:
Use this option with caution. Take note of current
settings first, especially those set by the operator if radar has
already been in active service.

Fuel settings

The fuel utility monitors a vessel's fuel consumption. This
information is totaled to indicate trip and seasonal fuel usage, and is
used to calculate fuel economy for display on instrument pages and
the data bar.
To use the utility, a Navico Fuel Flow sensor, or a NMEA 2000 engine
adaptor cable/gateway with Navico Fuel Data Storage device must
be fitted to the vessel. The Navico Fuel Flow sensor does not require
the use of a separate Fuel Storage device. Refer to the engine
manufacturer or dealer for information on whether or not your
engine provides a data output, and what adaptor is available to
connect to NMEA 2000.
Once the physical connection is made, ensure source selection is
completed. Multiple engine installations using Fuel Flow sensors, or
Fuel Data Storage devices, require setup of related engine location
in the Device list. For general source selection information, refer to
"Network settings" on page 221.
System setup| ELITE FS User Manual
217