Using Input Menu - Yamaha HTR-5990 Owner's Manual

Using INPUT MENU

Use to reassign digital input/outputs, select the input mode
or rename your inputs.
3 INPUT MENU 1/2
. A)I/O ASSIGNMENT
B)INPUT RENAME
C)VOLUME TRIM
D)DECODER MODE
[ ]/[ ]:Up/Down
[ENTER]:Enter
■ Input/output assignment
A)I/O ASSIGNMENT
You can assign jacks according to the component to be
used if this unit's initial settings do not correspond to your
needs. Change the following parameters to reassign the
respective jacks and effectively connect more components.
Once the inputs have been reassigned, you can select the
corresponding component by using the INPUT selector on
the front panel or the input selector buttons on the remote
control.
Note
The default settings are displayed with parentheses in the OSD.
Component video input CMPNT-V INPUT
Choices: DVD, DTV, CBL/SAT, VCR1, DVR/VCR2,
V-AUX
CMPNT-V INPUT
. [A];;;;;
[B];;;;;
[C];;;;;CBL/SAT
Coaxial input COAXIAL IN
Choices: MD/TAPE, CD-R, CD, PHONO, DVD, DTV,
CBL/SAT, VCR1, DVR/VCR2, V-AUX
COAXIAL IN
. (1);;;;;
(2);;;;;
(3);;;;;DVR/VCR2
Notes
• You cannot select a specific item more than once for the same
type of jack.
• When you connect a component to both the COAXIAL and
OPTICAL jacks, priority is given to the input signals from the
COAXIAL jack.
3 INPUT MENU 2/2
. E)MULTI CH SET
[ ]/[ ]:Up/Down
[ENTER]:Enter
DVD
( DVD )
DTV
( DTV )
(CBL/SAT)
CD
( CD )
DVD
( DVD )
(DVR/VCR2)
Optical input OPTICAL IN
Choices: MD/TAPE, CD-R, CD, PHONO, DVD, DTV,
CBL/SAT, VCR1, DVR/VCR2
OPTICAL IN 1/2
. (4);;;;;
(5);;;;;
(6);;;;;
Optical output OPTICAL OUT
Choices: MD/TAPE, CD-R, CD, PHONO, DVD, DTV,
CBL/SAT, VCR1, DVR/VCR2, V-AUX
OPTICAL OUT
. (8);;;;;MD/TAPE
(9);;;;;
HDMI input HDMI IN
Choices: DVD, DTV, CBL/SAT, VCR1, DVR/VCR2,
V-AUX
HDMI IN
. IN1;;;;;
IN2;;;;;CBL/SAT
MANUAL SETUP
CD
( CD )
DVD
( DVD )
DTV
( DTV )
(MD/TAPE)
CD-R
( CD-R )
DVD
( DVD )
(CBL/SAT)
81