Yamaha HTR-5990 Owner's Manual page 10

CONTROLS AND FUNCTIONS
7 FM/AM
Switches the reception band (FM or AM) when TUNER is
selected as the input source (see page 44).
Note
The frequency of the previously received station is automatically
recalled.
8 A/B/C/D/E
Selects one of the 5 preset station groups (A to E) when
TUNER is selected as the input source (see page 48).
9 PRESET/TUNING/CH l / h
Selects the preset station number (1 to 8) when TUNER is
selected as the input source and the colon (:) is displayed
next to the band indication in the front panel display.
Selects the tuning frequency when TUNER is selected as
the input source and the colon (:) is not displayed in the
front panel display.
See pages 44 to 49 for details.
0 Front panel display
Shows information about the operational status of this
unit.
A MEMORY (MAN'L/AUTO FM)
Stores a station in the memory when TUNER is selected
as the input source. Hold down for more than 3 seconds to
start automatic preset tuning (see page 45).
B TUNING MODE (AUTO/MAN'L), DISPLAY
Switches the tuning mode between automatic (the AUTO
indicator is turned on) and manual (the AUTO indicator is
turned off) when TUNER is selected as the input source.
C VOLUME
Controls the volume level of all audio channels.
Note
This does not affect the OUT (REC) level.
D OPTIMIZER MIC jack
Use to connect the supplied optimizer microphone to run
AUTO SETUP (see page 30).
E
PHONES (SILENT CINEMA) jack
Outputs audio signals for private listening with
headphones.
Notes
• When you connect headphones, no signals are output at the
PRE OUT jacks or to the speakers.
• All Dolby Digital and DTS audio signals are mixed down to 2-
channel stereo (front left and right channels).
F SPEAKERS A/B
Turn on or off the set of front speakers connected to the
SPEAKERS A and/or B terminals on the rear panel each
time the corresponding button is pressed.
6
G PURE DIRECT
Turns on or off the PURE DIRECT mode (see page 39).
Note
The indicator around the button lights up when the unit is in the
PURE DIRECT mode.
H STRAIGHT (EFFECT)
Turns the sound field programs on or off. When
STRAIGHT is selected, 2-channel or multi-channel input
signals are output directly from the respective speakers
without effect processing.
I PROGRAM selector
Use to select sound field programs or adjust the balance of
bass and treble in conjunction with TONE CONTROL.
J TONE CONTROL
Use to adjust the balance of bass and treble for the front
left and right and center channels (see page 36).
K AUDIO SELECT
Toggles the priority for the type of audio input jack
between AUTO, HDMI, COAX/OPT and ANALOG when
one component is connected to two or more input jacks on
the rear panel (see page 41).
L INPUT selector
Selects the desired input source.
M MULTI CH INPUT
Selects the input source connected to the MULTI CH
INPUT jacks. When selected, the MULTI CH INPUT
source takes priority over the input source selected with
the INPUT selector (or the input selector buttons on the
remote control).
N ZONE CONTROL
Switches the zone you want to control between the main
unit, Zone 2 and Zone 3 (see page 104).
After you press ZONE CONTROL, the indicator for the
currently selected zone flashes in the front panel display
for approximately 5 seconds. While the indicator is
flashing, perform the desired operation.
O VIDEO AUX jacks
Input audio and video signals from an external source such
as a game console. To reproduce source signals at these
jacks, select V-AUX as the input source.