Yamaha HTR-5990 Owner's Manual page 36

AUTO SETUP
4
Press k / n repeatedly to select WIRING,
DISTANCE, SIZE, EQ or LEVEL.
1 AUTO:MENU
. SETUP;;;;;;;AUTO
WIRING;;;;;;CHECK
DISTANCE;;;;CHECK
SIZE;;;;;;;;CHECK
EQ;;;;;;;;;;NATURAL
LEVEL;;;;;;;CHECK
START
[ ]/[ ]:Up/Down
[<]/[>]:Adjust
5
When WIRING, DISTANCE, SIZE or LEVEL is
selected, press l / h to select:
CHECK
To automatically check and adjust the selected item.
SKIP
To skip the selected item and perform no adjustments.
Note
When using THX speakers, set SIZE to SKIP and make sure
that SML or SMLx2 is selected in SPEAKER SET (see
page 76) and that 80Hz is selected in CROSS OVER (see
page 77).
When EQ is selected, press l / h to select:
NATURAL
To average out the frequency response of all speakers
with higher frequencies being less emphasized.
Recommended if the FLAT setting sounds a little
harsh.
FLAT
To average the frequency response of all speakers.
Recommended if all of your speakers are of similar
quality.
FRONT
To adjust the frequency response of each speaker in
accordance with the sound of your front speakers.
Recommended if your front speakers are of much
higher quality than your other speakers.
SKIP
To skip the selected item and perform no adjustments.
6
Press n to select START and then press
ENTER.
Loud test tones will be output from each speaker and
WAIT appears during the AUTO SETUP procedure.
Note
If E-10:INTERNAL ERROR appears during testing, restart
the procedure from step 3.
32
■ If you selected AUTO in step 5
The RESULT display appears for a few seconds after each
check, then settings of the next item will start. The
RESULT:EXIT display appears after all items are set.
RESULT:EXIT
WARNING
RESULT
.
SP:5/4/0.1
.
DIST:4.5/6.1m
.
LVL:-10.0/+6.5dB
. >SET CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Enter
7
Press k / n to select RESULT and then press
ENTER to display the AUTO SETUP results.
RESULT:WIRING
FRONT L;;;;;;;OK
[<]/[>]:Select
[ENTER]:Return
RESULT:DISTANCE1
FRONT L;;;;4.5m
CENTER;;;;;5.2m
FRONT R;;;;4.8m
PRNS L;;;;;5.2m
PRNS R;;;;;5.3m
[<]/[>]:Select
[ENTER]:Return
RESULT:SIZE
FRONT L;;;;;;LRG
[<]/[>]:Select
[ENTER]:Return
RESULT:EQ
CENTER 1:100Hz;;;+2.5dB
2:300Hz;;;-0.5dB
3:1.5kHz;;+0.5dB
4:1.8kHz;;+2.5dB
5:1.8kHz;;-3.5dB
6:2.5kHz;;+2.5dB
7:10kHz;;;+2.5dB
[<]/[>]:Select
[ENTER]:Return
RESULT:LEVEL1
FRONT L;;;+1.0dB
CENTER;;;;-1.5dB
FRONT R;;;+6.5dB
PRNS L;;;-10.0dB
PRNS R;;;;+1.0dB
[<]/[>]:Select
[ENTER]:Return
y
• Press l / h repeatedly to move between each display.
• If you are not satisfied with the result or want to manually
adjust each setup parameter, run MANUAL SETUP (see
page 73).
Results of the speaker
connection and wiring
Results of the speaker
distance from the
listening position
Results of the
frequency response of
each speaker
Results of the
parametric equalizer of
each speaker
Results of the volume
level of each speaker