Xm Satellite Radio - Yamaha HTR-5990 Owner's Manual

■ Tuner
Problem
FM stereo reception is
noisy.
There is distortion, and
clear reception cannot
be obtained even with a
FM good FM antenna.
The desired station
cannot be tuned in with
the automatic tuning
method.
Previously preset
stations can no longer
be tuned in.
The desired station
cannot be tuned in with
the automatic tuning
method.
There are continuous
AM
crackling and hissing
noises.
There are buzzing and
whining noises.

■ XM Satellite Radio

If an operation takes longer than usual or an error occurs, one of the following messages may appear in the front panel
display. In this case, read the cause and follow the corresponding remedies.
Status message
The XM Connect-and-Play digital antenna
CHECK ANTENNA
accessory is not connected, or does not
work properly.
The XM user encryption code is being
UPDATING
updated.
NO SIGNAL The signal is too weak.
It takes longer than four seconds for audio
LOADING
or text data to be decoded.
The XM Satellite Radio channel you
OFF AIR selected is not currently broadcasting any
signal.
The channel Station ID (SID) is no longer
<XM> - - -
available.
No artist name/feature or song/program
- - - / - - -
title is available.
No channels are available for the selected
<CAT> - - -
category.
Cause
The characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away or
the antenna input is poor.
There is multipath interference.
The signal is too weak.
This unit has been disconnected for a
long period.
The signal is weak or the antenna
connections are loose.
Noises result from lightning,
fluorescent lamps, motors,
thermostats and other electrical
equipment.
A TV set is being used nearby.
Cause
Remedy
Check the antenna connections.
Try using a high-quality directional FM
antenna.
Use the manual tuning method.
Adjust the antenna position to eliminate
multipath interference.
Use a high-quality directional FM antenna.
Use the manual tuning method.
Preset the stations again.
Tighten the AM loop antenna connections
and orient it for the best reception.
Use the manual tuning method.
Use an outdoor antenna and a ground wire.
This will help somewhat, but it is difficult to
eliminate all noise.
Move this unit away from the TV.
Remedy
Check the XM Connect-and-Play digital antenna
accessory connections.
Wait until the encryption code is updated.
Check the XM Connect-and-Play digital antenna
accessory connections and orient it for the best
reception.
Wait until the decoding process has finished.
Check the channel number again or select another
XM Satellite Radio channel.
Select another channel category by pressing
CATEGORY (or A-E/CAT. l / h on the remote
control) repeatedly.
TROUBLESHOOTING
See
page
27
45
—
27
45
45
—
45
—
—
See
page
50
—
50
—
53
53
111