Yamaha HTR-5990 Owner's Manual page 116

TROUBLESHOOTING
■ Remote control
Problem
The remote control
does not work or
function properly.
The remote control
does not learn new
functions.
112
Cause
Wrong distance or angle.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
AMP/SOURCE/TV is set incorrectly.
The remote control code was not correctly
set.
The library code of the remote control and
the remote control ID of this unit do not
match.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
The batteries of this remote control and/or
the other remote control are too weak.
The distance between the two remote
controls is too much or too little.
The signal coding or modulation of the
other remote control is not compatible
with this remote control.
Memory capacity is full.
Remedy
The remote control will function within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
Reposition this unit.
Replace all batteries.
Set AMP/SOURCE/TV correctly.
When operating this unit, set it to the AMP position.
When operating the component selected by the input
selector button, set it to the SOURCE position.
When operating the TV set in the DTV or PHONO
area, set it to the TV position.
Set the remote control code correctly using
"LIST OF REMOTE CONTROL CODES" at the end
of this manual.
Try setting another code of the same manufacturer
using "LIST OF REMOTE CONTROL CODES" at
the end of this manual.
Match the remote control ID of this unit with the
corresponding remote control library code.
Program the necessary functions independently into
the programmable buttons using the Learn feature.
Replace the batteries.
Place the remote controls at the proper distance.
Learning is not possible.
Delete other unnecessary functions to make room for
the new functions.
See
page
4
—
4
—
92
92
89, 92
94
4
94
—
99