Bowflex Treadmill 10 Assembly & Owners Manual page 55

Walking belt not aligned
Motor sounds strained
Hesitation or walking belt slips
when in use
Belt stops moving while in use
Console continuously displays a
video of machine features
Machine leveling
Walking belt tension and align-
ment
Walking deck
Belt tension
Safety key
Motor overload
Console is in demonstration
mode
Assembly / Owner's Manual
Make sure the machine is level. Refer to the procedure for leveling the
machine in this manual.
Make sure the walking belt is centered and tension is correct. Refer to the
procedures for adjusting tension and aligning the belt in this manual.
Apply a thin layer of silicone lubricant on the entire deck below the belt. Refer
to the belt lubrication procedure in this manual.
Adjust the belt tension at the rear of the machine. Refer to the procedure for
adjusting belt tension in this manual.
Plug Safety Key into Console. (See Emergency Stop Procedure in the Impor-
tant Safety Instructions section.)
Unit may be overloaded and draw too much current, which causes power to
turn off to protect motor. Refer to maintenance schedule for belt lubrication.
Make sure the walking belt tension is correct, and start unit again.
If the above steps do not resolve the problem, contact Customer Service (if
inside US/Canada) or your local distributor (if outside US/Canada) for further
assistance.
Tap on the upper-right corner of the
mode app", and then tap on the "De-activate Demo mode" option.
55
console display ten times. Tap on "Demo