Connecting The Fm And Am Antennas; Connecting The Power Cable - Yamaha RX-V463 Owner's Manual

Connections
Connecting the FM and AM
antennas
Both FM and AM indoor antennas are supplied with this
unit. Connect each antenna correctly to the designated
terminals. In general, these antennas should provide
sufficient signal strength.
y
See right for connection information of the supplied AM loop
antenna.
Notes
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
• A properly installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality,
install an outdoor antenna. Consult the nearest authorized
Yamaha dealer or service center about outdoor antennas.
Outdoor AM antenna
Use a 5 to 10 m (16 to 33
ft) vinyl-covered wire
extended outdoors from a
window.
S DOCK
ANTENNA ANTENNA
L
AM AM
R
GND GND
FM FM
75 75
UNBAL. UNBAL.
SUB
WOOFER
CENTER
TPUT
Ground (GND terminal)
For maximum safety and minimum interference, connect the
GND
antenna terminal to a good earth ground. A good earth
ground is a metal stake driven into moist earth.
20
En
AM loop Indoor FM
antenna antenna
(supplied) (supplied)
(U.S.A. model)
Connecting the wire of the AM loop antenna
Open the lever
y
The wire of the AM loop antenna does not have any polarity
and you can connect either end of the wire to AM or GND
terminal.
Assembling the supplied AM loop antenna
Note
The types of the supplied AM loop antenna is different
depending on the models.

Connecting the power cable

Once all connections are complete, plug the power cable
into the AC wall outlet.
Insert
Close the lever
(U.S.A. model)
Power cable