About This Document - Siemens FC700A Maintenance Instructions Manual

1

About this document

Group of persons
Commissioning personnel
Siemens Building Technologies
Fire & Security Products
Purpose
These guidelines assume that commissioning has bee carried out in accordance
with the existing guidelines, i.e. that all functions have been tested, system data
has been saved and archived.
Scope
This instruction covers the maintenance work on the control unit type FC700A with
standard equipment. They are a basic part of the general maintenance guidelines
for fire detection systems and must be applied for all periodic maintenance work.
Protocol
The values to be measured (as specified in this procedure) are part of the technical
documentation in the system logbook.
Target groups
This product documentation and the work instructions are aimed at the following
persons, who have a particular function and have the corresponding training and
qualification.
Activity
The configuration of the products, devices or
systems for specific customers at the place of
installation.
They check serviceability and officially clear the
product, device or system for use by the operator
/ customer. They are also responsible for trouble-
shooting.
Reference documents
Information in
007831
007836
007827
007832
007835
007828
007894
007895
Work and operational safety
Before personnel begin work on the system they must have read and understood the related operating
instructions, in particular chapter 2 "Safety regulations".
Systems or parts of systems should not be left switched off unnecessarily in
order that the system is not too long out of commission.
Never connect or disconnect electronic modules while the power supply is
NOTE switched on. Always switch off the mains and battery supply first.
Avoid electrostatic discharge. The FC700A hardware consists mainly of circuits
with CMOS technology. When working with the modules, use the ESD protec-
tion mat. Do not unnecessarily touch components or p.c.b. tracks.
Qualification
They have had the professional training appropri-
ate to their function and to the commissioning of
the products, systems and devices and have
attended the technical training courses for com-
missioning personnel.
Document
Hardware description
Planning
Installation housing H26... /H28...
Visualizer Customizing / End User (not yet available)
Operating instructions
Installation / Hardware Commissioning
Templates for inscription stripes
Operating platform for Tools
About this document
5
007833_a_en_--.doc
03.2004