Panasonic KX-TGH260BX Operating Instructions Manual page 14

Getting Started
To activate these features, their Smart
Function Key must be "On". (page 14)
Using the Smart Function Key (
key)
When the indicator flashes rapidly/slowly,
press M N.
R The above features can be activated
depending the situation.
R If you answer a call using the Smart
Function Key, the speakerphone is
activated.
R Even if the handset is placed on the base
unit or charger, the feature can be
activated. You can talk or listen to new
messages without lifting up the handset. If
you want to perform further operations, lift
up the handset.
R When the unit has new messages and
missed calls, the unit can be operated to
play the new messages first and then show
the missed calls.
Note:
R While key lock is on (page 24), incoming
calls can be answered, but the following
features are disabled even when the
indicator flashes slowly.
– Listen to new messages. (page 54)
– View the caller list when there are
missed calls. (page 47)
Setting the Smart Function Key
The Smart Function Key for the following
features must be "On".
– "New Message" (Default: On)
– "Missed Call" (Default: Off)
The settings can be set for each handset.
1
M N (right soft key) #278
2
MbN: Select the desired setting and press
M N.
R " " is displayed next to the selected
features.
R To cancel a selected feature, press
M N again. " " disappears.
3
MOKN a M N
14
Note:
R If the indicator flashes when the
handset is not placed on the base unit or
charger, battery consumption is faster than
usual.
Screen saver mode
The backlight goes dark when on a call or
turns off completely after 1 minute of
inactivity if the handset is not on the base unit
or charger.
Activate the handset display again by:
– pressing M N when on a call.
– pressing M N at all other times.
Eco mode setting
You can select the desired eco mode setting
by pressing MR/ECON.
The following settings are available for eco
mode.
– "Eco": Reduces the base unit transmission
power by up to 90 % in standby mode.
When this setting is selected,
displayed on the handset display instead of
.
– "Eco Off" (default setting): Turns off eco
mode.
When this setting is selected,
displayed in the handset display.
Note:
R When there is another cordless phone in
use nearby, the base unit transmission
power may not be reduced.
R When eco mode is active, the range of the
base unit is reduced in standby mode.
R If you set repeater mode to "On"
(page 45):
– Eco mode is disabled.
– "Eco Mode" is not displayed in the
display menu (page 36).
Dialling mode
If you cannot make calls, change this setting
according to your telephone line service. The
default setting is "Tone".
"Tone": For tone dial service.
is
is not