Yamaha DSP-Z9 Owner's Manual page 97

3
Press an input selector button to select the
input source you want to listen to in the
second room.
The display window shows "2: name of selected
input".
CABLE SAT
DTV/LD VCR 1
Note
Signals input to V-AUX and PHONO jacks cannot be sent to
Zone 2.
4
You can control this unit from Zone 2 using
the input selector, STANDBY, SYSTEM
POWER, MUTE and VOLUME +/– buttons.
MACRO
TRANSMIT RE-NAME CLEAR LEARN MACRO OFF ON
SYSTEM
STANDBY V-AUX TUNER PHONO
POWER
CABLE SAT MD/TAPE CD-R CD
DTV/LD VCR 1 VCR 2 DVR DVD
MULTI CH IN
PURE DIRECT
TITLE
ENTER
SOURCE
TOP EXIT
INPUT MODE
DISPLAY MENU SOUND
SELECT SEARCH – CHAPTER +
POWER REC STOP PAUSE PLAY
10KEY AMP STEREO HALL CHURCH JAZZ
* VOLUME +/– can only be used when Variable is selected
in Zone 2 Volume (see page 78). Further, you cannot
adjust the volume of signals output from ZONE 2
COAXIAL OUT.
5
Press SOURCE SELECT k/n to exit from the
Zone 2 mode.
Notes
• The source in Zone 2 and the source available for recording are
always the same.
• "Zone 2" appears in the display window only when k is
pressed, and SYSTEM only when n is pressed.
V-AUX TUNER PHONO
MD/TAPE CD-R CD
VCR 2 DVR DVD
10KEY AMP STEREO HALL 1 HALL 2 CHURCH
1 2 3 4
JAZZ ROCK MUSIC ENTERTAIN
5 6 7 8
6.1/5.1 MOVIE THX /DTS NIGHT
9 0 +10 +100
CHP/INDEX
A/B/C/D/E PRESET
TV INPUT MUTE *
TV VOL CH VOLUME
TV MUTE STRAIGHT
DISC EFFECT
PUSH
Turning this unit to either on or standby
SYSTEM POWER and STANDBY work differently
depending on the selected mode that appears on the
display window.
• When the Normal or Zone2 mode is selected, you can
turn the main unit or Zone 2 to on/standby individually.
• When the System mode is selected, or when YPC is
selected as the amplifier library (L:AMP) code, you
can turn the main unit and Zone 2 to on/standby
simultaneously.
LCD display
Normal mode* Name of component
Zone 2 mode "Zone 2" or "2:name
of component"
SYSTEM mode
"SYSTM"
*
"MAIN" appears for a few seconds when SYSTEM POWER
or STANDBY is pressed.
Special considerations for DTS software
The DTS signal is a digital bitstream. If you attempt to
send the DTS signal to the second room you will only hear
digital noise (that may damage your speakers). Thus, the
following considerations and adjustments need to be made
when playing DTS encoded discs.
For LDs or DVDs encoded with DTS
Only 2 channel analog audio signals may be sent to the
second/third room.
• for LDs: Set your LD player's left and right outputs to
the analog soundtrack.
• for DVDs: Use the disc menu to set the DVD player's
mixed 2-channel left and right audio outputs to the
PCM or Dolby Digital soundtrack.
For CDs encoded in DTS
To avoid unexpected noise, DO NOT USE the Zone 2
feature with CDs encoded in DTS.
ZONE 2
SYSTEM POWER/
STANDBY
Turns the main unit
to on/standby
Turns Zone 2 to on/
standby
Turns everything (the
main unit and Zone
2) to on/standby
95