Error Messages; Trouble Shooting - Yamaha DG60FX-112 Owner's Manual

Error Messages

If an error occurs during operation, one of the following error message numbers will appear
on the display.
E1
: MIDI Receive Buffer Full
CAUSE:
SOLUTION: Try reducing the amount of data being sent or, break the data into smaller blocks.
E2
: Communication Error.
CAUSE:
SOLUTION: Check all connections, etc. and try again.
E3
: Bulk Receive Check Sum Error.
CAUSE:
SOLUTION: Check all connections and data, and try again.
E4
: Bulk Receive Data Abnormality.
CAUSE:
SOLUTION: Check all connections and data, and try again.
E5
: Backup Battery Error.
CAUSE:
SOLUTION: Continued use of the device will result in the loss of data. Return the device to the

Trouble Shooting

No Sound
Is the power plug properly connected?
Is the volume level on the guitar amplifier turned
up?
Is the GAIN knob value set to "0"?
Is the MASTER knob value set to "0"?
Is the OUTPUT knob value set to "0"?
If an EXP pedal is being used to control the
volume, try stepping on the pedal.
Is the Tuner Mode active? Press the [UTIL-
ITY] button or the BANK switch to return to the
Play Mode.
Is a cable connected to the MAIN AMP IN jack?
Turning the Knobs Does Not Change the
Sound
Turn the knob until the value in the display
changes, then adjust the setting. (
28
Too much MIDI data is being received by the DG amplifier at one time.
An abnormality is detected during MIDI communications.
The check sum does not match the received MIDI bulk data.
An abnormality is detected in the received MIDI bulk data.
Backup battery power is depleted.
music dealer where you purchased it or, the nearest Yamaha Service center and
have the battery replaced.
page 13).
Is that knob's effect switched ON? After se-
lecting the effect, by pressing the effect but-
ton, turn the knob to adjust the setting. (
13)
Can Not Transmit MIDI
Is the MIDI channel matched with MIDI chan-
nel on the receiving device? (
Is the MIDI Merge set to "OFF"? (
Can Not Receive MIDI
Is the DG60FX-112 in the Play Mode? Return
to the Play Mode and try receiving again.
Is the DG60FX-112's MIDI channel set to
"OFF"? ( page 24)
page
page 24)
page 24)