Installation Checklist - Chamberlain Elite CSW-200-UL Owner's Manual

Installation Checklist

1. Owner and Installer must read all warnings and safety precautions. (Pages 3-7)
2. Make sure concrete mounting pad is big enough and deep enough for operator. (Page 9)
3. Operator must be securely fastened to concrete pad or mounting plate. (Page 9)
4. Operator arm must be level and welded properly to gate. (Page 13)
5. Rectangular tubes on operator arm must be completely welded around. (Page 13)
6. When gate is pulled, No slippage of operator arm should occur. (Page 13)
7. Gate operator to be grounded to an earth ground rod within 3 feet of operator. (Page 16)
8. Verify that AC power is connected properly and Property Owner knows how to shut off power to operator. (Page 17)
9. Verify that the gate opens and closes as needed. (Page 26)
10. When gate hits object during operation, it must stop or reverse direction. (Page 31)
11. Know how to operate the emergency manual release. (Page 35)
12. Make sure that any pinch point or potential entrapment are guarded by means of safety devices or like. (Pages 24-25)
13. Warning placards need to be permanently mounted on both sides of gate. (Page 7)
14. Test all additional equipment connected to operator.
15. Make sure all wire connections are securely fastened.
16. Review typical maintenance on operator. (Page 33)
17. Schedule periodic maintenance on operator by qualified service technician.
18. Inquire about Manufacturers "operator warranty." (Warranty Card Included with operator)
19. Inquire about separate "installation warranty" with installer.
Installer Company Name, Address and Phone Number
Date Installed:
47