Air Intake; Lubrication; Cutting-Means Assy; Assistance And Repairs - Stiga Park series 2WD Instruction Manual

(Translation of the Original Instructions)
For further information, please contact
your dealer .
To charge the battery connect the battery char-
ger to the side socket (8:F).

9 .8 .3 AIR INTAKE

For the frequency of this intervention
see chapter 13 .
See figure (14:A). The engine is air-cooled. A blo-
cked cooling system can damage the engine.
9 .9

LUBRICATION (16)

For the frequency of this intervention
see chapter 13 .
Object
Action
Centre Lubricate with oil at the
point centre point.
Steering Brush the chains clean with
chains a wire brush.
Lubricate with universal
chain spray.
Steering Lubricate the pulley pins
with oil.
pulleys
Ten- Lubricate the support points
with oil when each control is
sioning
activated.
arms
Ideally this operation should
be carried out by two
people.
Control Lubricate the cable ends
cables with oil when each control is
activated.
This operation must be
carried out by two people.
Front Remove the wheels and
wheel handles of the quick con-
axle. nectors.
Lubricate the axles with
grease.

9 .10 CUTTING-MEANS ASSY

For maintenance operations on the cutting means
assembly, please refer to the instructions provided
in the relative manual.
ENGLISH

10 ASSISTANCE AND REPAIRS

This manual provides all the necessary informa-
tion to run the machine and for correct basic main-
tenance operations which can be performed by
the user. Any regulations and maintenance opera-
tions not described herein must be carried out by
your Dealer or Authorized Service Centre, which
have the necessary knowledge and equipment
to ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Before performing any servicing ope-
rations:
a . Place the machine on a flat surface.
b . Apply the parking brake .
c . Turn off the engine.
Fig .
d . Remove the key from the ignition .
16:A
Authorized service workshops carry out gua-
ranteed repairs and maintenance. Always use
genuine spare parts.
-
Genuine GGP spare parts and acces-
sories have been designed specifically
for GGP machines . Please remember
that non-genuine spare parts and ac-
16:B
cessories have not been verified or ap-
proved by GGP .
16:C
The use of non-genuine spare parts and
accessories could adversely affect ma-
chine operation and safety . GGP shall
decline all liability in the event of injuries
or damages caused by such parts .
Genuine spare parts are supplied by
16:D
authorized assistance workshops and
dealers .
It is advisable to send your machine
once a year to an authorized service
workshop for servicing, assistance and
16:E
safety device inspection .
EN
19